To Next Page

To Previous Page

Expansion memory module

Description Spare part number

2048-MB, PC2-5300, 1-DIMM memory module 417506-001

1024-MB, PC2-5300, 1-DIMM memory module 414046-001

512-MB, PC2-5300, 1-DIMM memory module 414045-001

Before removing the expansion memory module, follow these steps:

1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the

computer on, and then shut it down through the operating system.

2. Disconnect all external devices connected to the computer.

3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and

then unplugging the AC adapter from the computer.

4. Remove the battery (see

Battery on page 46).

Remove the expansion memory module:

1. Loosen the Phillips PM2.0×5.0 screw (1) that secures the memory/WLAN module compartment

cover to the computer.

2. Lift the rear edge of the cover (2), swing it forward, and remove the cover.

NOTE: The memory/WLAN module compartment cover is included in the Plastics Kit, spare part

number 443905-001.

3. Spread the retaining tabs (1) on each side of the memory module slot to release the memory

module. (The edge of the module opposite the slot rises away from the computer.)

54 Chapter 4 Removal and replacement procedures

Other manuals for HP COMPAQ 6510B

Questions and Answers:

Need help?

Do you have a question about the HP COMPAQ 6510B and is the answer not in the manual?

General