EasyManuals Logo

HP Compaq d530 MT User Manual

HP Compaq d530 MT
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
Hardware Reference Guide www.hp.com 2–7
Hardware Upgrades
Installing Additional Memory
The computer comes with double data rate synchronous dynamic
random access memory (DDR-SDRAM) dual inline memory
modules (DIMMs).
DIMMs
The memory sockets on the system board can be populated with up to
four industry-standard DIMMs. These memory sockets are populated
with at least one preinstalled DIMM. To achieve the maximum
memory support, you can populate the system board with up to 4GB
of memory configured in a high-performing dual channel mode.
DDR-SDRAM DIMMs
For proper system operation, if the computer supports DDR-SDRAM
DIMMs, the DIMMs must be:
industry-standard 184-pin
unbuffered PC2100 266 MHz-, PC2700 333 MHz-, or PC3200
400 MHz-compliant
2.5 volt DDR-SDRAM DIMMs.
The DDR-SDRAM DIMMs must also:
support CAS latency 2 or 2.5 (CL = 2 or CL = 2.5)
contain the mandatory JEDEC SPD information
In addition, the computer supports:
128Mbit, 256Mbit, and 512Mbit non-ECC memory technologies
single-sided and double-sided DIMMS
DIMMs constructed with x8 and x16 DDR devices; DIMMs
constructed with x4 SDRAM are not supported
The following processor bus frequencies are required for the system
to run at the supported memory frequencies.

Table of Contents

Other manuals for HP Compaq d530 MT

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Compaq d530 MT and is the answer not in the manual?

HP Compaq d530 MT Specifications

General IconGeneral
BrandHP
ModelCompaq d530 MT
CategoryDesktop
LanguageEnglish

Related product manuals