Hardware Reference Guide www.hp.com 2ā25
Hardware Upgrades
6. Connect the opposite end of the data cable to the appropriate
system board connector.
ā
If your system has only one SATA hard drive, you must connect the
hard drive to the connector labeled SATA 0 first to avoid any hard
drive performance problems.
Hard Drive Connector Locations
7. Replace the computer access panel.
8. If you normally lock the Smart Cover Lock, use Computer Setup
to relock the lock and enable the Smart Cover Sensor.
9. Reconfigure the computer, if necessary. Refer to the Computer
Setup (F10) Utility Guide on the Documentation Library CD for
instructions about using Computer Setup.
1 SATA hard drive connector
2 PATA hard drive connector
To Next Page
Loading...
