After installing the media card reader and booting to Windows, the reader and the inserted cards are not recognized
by the computer.
Cause
Solution
The operating system needs time to recognize the device if the
reader was just installed into the computer and you are turning
the PC on for the first time.
Wait a few seconds so that the operating system can recognize
the reader and the available ports, and then recognize
whatever media is inserted in the reader.
After inserting a media card in the reader, the computer attempts to boot from the media card.
Cause
Solution
The inserted media card has boot capability. If you do not want to boot from the media card, remove it during
boot or do not select the option to boot from the inserted media
card during the boot process.
Computer will not boot from a USB removable drive or media that is inserted in the USB port on the media card reader.
Cause
Solution
The media card reader is connected to the computer via the
PCI card, which is not supported on the HP Desktop BIOS.
The bootable USB device will have boot support if you connect
the media card reader to an available USB connector on the
computer’s system board. If no connector is available, plug the
bootable device into a different USB port on the computer.
After installing the media card reader, the front USB ports on the computer do not work.
Cause
Solution
The USB cable for the front USB ports was disconnected so
that the system board connector could be used for the reader.
Reconnect the cable for the front USB ports. Install the PCI
card and connect the media reader to the USB connector on
the PCI card.
Table 2-5 Solving Media Card Reader Problems (continued)
ENWW Solving Media Card Reader Problems 21
To Next Page
Loading...
Need help?
General
