EasyManua.ls Logo

HP Compaq Pro 4300 - 7 Removal and Replacement Procedures Small Form Factor (SFF) Chassis; Disassembly Preparation and Basic Panel Removal

HP Compaq Pro 4300
162 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
5. Using your fingers, press the visible edge of the optical disc drive toward the side of the
computer to push the drive partially out of the computer. Grasp the front end of the drive and pull
the drive out of the computer.
Figure 6-11 Removing the optical disc drive
6. If you need to remove the drive bracket from the drive, remove the two screws (1) that secure
the bracket to the drive, and then remove the bracket from the drive (2).
NOTE: Optical drive spare part kits do not include replacement brackets.
Figure 6-12 Removing the optical drive bracket
To install an optical drive, reverse the removal procedures.
Optical Drive 41

Table of Contents

Other manuals for HP Compaq Pro 4300

Related product manuals