Top Panel
The top panel is secured with two Torx screws. Removing it allows access to the webcam and allows
you to remove the main rear cover.
Figure 6-36 Top panel location
To remove the top panel:
1. Prepare the computer for disassembly (see
Preparing to Disassemble the Computer
on page 33).
2. Remove the center access panel (see
Hinge Cover Panel on page 34).
3. Remove the memory access panel (see
Memory Access Panel on page 36).
4. Remove the drive access panel (see
Drive Access Panel on page 38).
5. On the top of the computer, remove the two black Torx screws (1) that secure the top panel to
the computer.
6. Rotate the top of the panel outward (2), and then lift the panel off the computer.
Figure 6-37 Removing the top panel
To replace the top panel, reverse the removal procedures.
58 Chapter 6 Removal and Replacement Procedures All-in One (AIO) Chassis
To Next Page
Loading...
