2. Grasp the rear port cover, then pull it down and off the computer.
Figure 2-2 Removing the Rear Port Cover
Connecting Power
1. If the rear port cover is installed, remove the cover.
2. Route the power connector through the opening in the stand to take advantage of the cable
management feature.
3. Plug the power cord into the power connection on the rear of the computer (1).
4. Plug the three-pronged power plug into a power outlet (2).
Figure 2-3 Connecting Power
5. Route all peripheral cables through the stand opening and plug them into the appropriate ports as
needed.
10 Chapter 2 Hardware Repair and Upgrade
To Next Page
Loading...
