4. If your second display does not have a DisplayPort connector, connect a DisplayPort video
adapter to the DisplayPort connector of the computer. Then connect a cable (VGA, DVI. or HDMI,
depending on your application) between the adapter and a second display.
NOTE: When a display port adaptor is used, the rear port cover cannot be installed unless a
display port extender cable is used in conjunction with the adaptor.
Figure 2-17 Connecting a Second Display Using a DisplayPort Adapter
5. Replace the rear port cover on the computer.
6. Turn on power to the computer and the second display.
NOTE: Use the graphics card software or the Windows Display Settings to configure the second
display as a mirrored image of the primary display or an extension of the primary display.
Locating Internal Components
The following sections contain procedures for removing and replacing these internal components:
●
Memory
●
Battery
20 Chapter 2 Hardware Repair and Upgrade
To Next Page
Loading...
