2-18 Hardware Upgrades
Compaq Confidential - Need to Know Required
Writer: Beth Zanca Part Number: 190709-001 File Name: ch2.doc
Last Saved On: 04/12/00 1:02 PM Last Saved By: Lydia Sanchez
Removing the Cooling Shield
A cooling shield covers bays 5 and 6 to provide proper cooling and
EMI protection. The cooling shield must be removed before installing a
hard drive in either of these bay locations.
To remove a cooling shield:
1. Turn off the workstation and any external devices.
2. Disconnect the power cord from the grounded AC outlet and the
back of the workstation.
3. Remove the workstation access panel and front bezel.
4. Refer to the following illustration to remove a cooling shield.
Removing a cooling shield
5. Replace the shield after the drive is installed in the bay.
To replace the cooling shield, reverse the above procedure.
To Next Page
Loading...
