2-20 Hardware Upgrades
Compaq Confidential - Need to Know Required
Writer: Beth Zanca Part Number: 190709-001 File Name: ch2.doc
Last Saved On: 04/12/00 1:02 PM Last Saved By: Lydia Sanchez
Installing a Drive
Installing a Hard Drive in Bays 5 and 6
Drive bays 5 and 6 can be configured with either 1.0-inch or 1.6-inch
hard drives. Other than using different screw holes, the installation for
both drives is basically the same.
CAUTION: Use only 3/16-inch guide screws. Longer screws can
damage the internal components of the drive.
✎
If you are installing a SCSI device, read the section SCSI
Devices and Guidelines in the Appendix C.
To install a hard drive in bays 5 or 6:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the Workstation access panel. Refer to Removing the
Workstation Access Panel in this chapter.
3. Remove the front bezel. Refer to Removing the Front Bezel in
this chapter.
4. Remove the cooling shield. Refer to Removing the Cooling
Shield in this chapter.
5. Refer to the following illustrations to install a hard drive in bay 5
or bay 6.
Installing a hard drive in the hard drive bracket
To Next Page
Loading...
