Compaq Professional Workstation SP750 Hardware Reference Guide 2-23
Compaq Confidential - Need to Know Required
Writer: Beth Zanca Part Number: 190709-001 File Name: ch2.doc
Last Saved On: 04/12/00 1:02 PM Last Saved By: Lydia Sanchez
Installing a Hard Drive in the Removable Hard Drive Cage (Bays 1-3)
The removable hard drive cage can be configured with up to three
1.0-inch hard drives or two 1.6-inch hard drives. Other than using
different screw holes, the installation for both types of drives is
basically the same.
✎
Prior to installing a SCSI device, read the instructions SCSI
Devices and Guidelines in the Appendix C.
To install a 1.0-inch hard drive in the removable hard drive cage:
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the workstation access panel and the removable hard
drive cage.
3. Remove four of the hard drive screws (top group of screws) from
the side of the air plenum located at the front of the workstation.
See Locating the Hardware Screws in this chapter.
4. Install the screws into the drive cage. Refer to the following
illustration for screw locations.
Locating the hard drive screw holes
1 1.0-inch drive
2 1.6-inch drive
3 1.0-inch drive
4 1.0-inch or 1.6-inch drive
To Next Page
Loading...
