Advanced Tasks
Managing ProtectTools Settings
Some of the features of ProtectTools Security Manager can be managed in BIOS Configuration.
Enabling and Disabling Java Card Power-On Authentication Support
If this option is available, enabling it allows you to use the Java Card for user authentication when you
turn on the computer.
NOTE To fully enable the Power-On Authentication feature, you must also configure the Java
Card using the Java Card Security for ProtectTools module.
To enable Java Card Power-On Authentication support:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, select BIOS Configuration.
3. Enter your Computer Setup administrator password at the BIOS administrator password prompt,
and then click OK.
4. In the left pane, select Security.
5. Under Java Card Security, select Enable.
NOTE To disable Java Card Power-On Authentication, select Disable.
6. Click Apply, and then click OK in the ProtectTools window to save your changes.
Enabling and Disabling Power-On Authentication Support for Embedded Security
If this option is available, enabling it allows the system to use the TPM embedded security chip for user
authentication when you turn on the computer.
NOTE To fully enable the Power-On Authentication feature, you must also configure the TPM
embedded security chip using the Embedded Security for ProtectTools module.
To enable Power-On Authentication support for embedded security:
1. Select Start > All Programs > HP ProtectTools Security Manager.
2. In the left pane, select BIOS Configuration.
3. Enter your Computer Setup administrator password at the BIOS administrator password prompt,
and then click OK.
4. In the left pane, select Security.
5. Under Embedded Security, select Enable Power-On Authentication Support.
NOTE To disable Power-On Authentication for Embedded Security, select Disable.
6. Click Apply, and then click OK in the ProtectTools window to save your changes.
6 Chapter 1 Introduction ENWW
To Next Page
Loading...
Need help?
General
