Setup Procedures
CAUTION To reduce security risk, it is highly recommended that the IT administrator
immediately initialize the TPM embedded security chip. If the TPM embedded security chip is not
initialized, an unauthorized user or a computer worm could gain access to the computer or a virus
could initialize the TPM embedded security chip and restrict access to the PC.
The TPM embedded security chip can be enabled in the BIOS Computer Setup utility, BIOS
Configuration for ProtectTools, or HP Client Manager.
To enable the TPM embedded security chip:
1. Open Computer Setup by turning on or restarting the computer, and then pressing F10 while
the F10 = ROM Based Setup message is displayed in the lower-left corner of the screen.
2. Use the arrow keys to select Security > Setup Password. Set a password.
3. Select Embedded Security Device.
4. Use the arrow keys to select Embedded Security Device—Disable. Use the arrow keys to change
it to Embedded Security Device—Enable.
5. Select Enable > Save changes and exit.
NOTE Refer to the ProtectTools Help screens for specific instructions for ProtectTools
Embedded Security.
14 Chapter 3 HP Embedded Security for ProtectTools ENWW
To Next Page
Loading...
