Short description Details Solution
Resetting System ROM to
default hides TPM.
Resetting the system ROM to default
hides the TPM to Windows. This does
not allow the security software to operate
properly and makes TPM-encrypted data
inaccessible.
Unhide the TPM in BIOS:
Open the Computer Setup (F10) Utility, navigate to
Security > Device security, modify the field from
Hidden to Available.
Automatic backup does
not work with mapped
drive.
When an administrator sets up
Automatic Backup in Embedded
Security, it creates an entry in
Windows > Tasks > Scheduled Task.
This Windows Scheduled Task is set to
use NT AUTHORITY\SYSTEM for rights
to execute the backup. This works
properly to any local drive.
When the administrator instead
configures the Automatic Backup to save
to a mapped drive, the process fails
because the NT AUTHORITY\SYSTEM
does not have the rights to use the
mapped drive.
If the Automatic Backup is scheduled to
occur upon login, Embedded Security
TNA Icon displays the following
message: The Backup Archive
location is currently not accessible.
Click here if you want to backup to a
temporary archive until the Backup
Archive is accessible again. If the
Automatic Backup is scheduled for a
specific time, however, the backup fails
without displaying notice of the failure.
The workaround is to change the NT AUTHORITY
\SYSTEM to (computer name)\(admin name). This is
the default setting if the Scheduled Task is created
manually.
HP is working to provide future product releases with
default settings that include computer name\admin
name.
Unable to disable
Embedded Security State
temporarily in Embedded
Security GUI.
The current 4.0 software was designed
for HP Notebook 1.1B implementations,
as well as supporting HP Desktop 1.2
implementations.
This option to disable is still supported in
the software interface for TPM 1.1
platforms.
HP will address this issue in future releases.
32 Chapter 8 Troubleshooting ENWW
To Next Page
Loading...
