14
4. Type the user name and password. The default username is admin and the password is what you set
during AMT Setup in the MEBx.
Figure 6 Intel AMT WebGUI Screen
5. Review system information and/or make any necessary changes.
NOTE: You can change the MEBx password for the remote system in the WebGUI.
Changing the password in the WebGUI or a remote console results in two passwords. The new
password, known as the “remote” MEBx password, only works remotely with the WebGUI or
remote console. The local MEBx password used to locally access the MEBx is not changed. The
user has to remember both local and remote MEBx passwords to access the system MEBx locally
and remotely.
When the MEBx password is initially set in AMT Setup, the password serves as both the local and
remote password. If the remote password is changed, then the passwords are out of sync.
The remote MEBx password must follow the criteria defined in the Password Guideline section for
a strong password.
6. Select Exit.
To Next Page
Loading...
