Declaration of conformity 23
Declaration of conformity
According to ISO/IEC 17050-1 and EN 17050-1
declares that the product
conforms to the following product specifications
The product herewith complies with the requirements of the Low-Voltage Directive 2006/95/EC,
the EMC Directive 2004/108/EEC, the Machinery Directive 2006/42/EC, and carries the
marking accordingly. In addition, it complies with the WEEE Directive 2002/96/EC and
RoHS Directive 2002/95/EC.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
• This device may not cause harmful interference.
• This device must accept any interference received, including interference that may cause
undesired operation.
Additional information
The product is assigned a Regulatory Model Number which stays with the regulatory aspects of
the design. The Regulatory Model Number is the main product identifier in the regulatory
documentation and test reports; this number should not be confused with the marketing name or
the product numbers.
Local contacts for regulatory topics only
http://www.hp.com/go/certificates/
EMEA contact: Hewlett-Packard GmBH, HQ-TRE, Herrenberger Strasse 140, 71034 Böblingen,
Germany.
USA contact: Hewlett-Packard Company, Corporate Product Regulations Manager, 3000
Hanover Street, Palo Alto, CA 94304, USA. Phone: (650) 857 1501.
Declaration of conformity number BCLAA-0904
Supplier’s name: Hewlett-Packard Company
Supplier’s address: Cami de Can Grasells, 1-21
08174 Sant Cugat del Vallès
Barcelona, Spain
Product name and model: HP Designjet 3D Removal System
Regulatory Model Number(1): BCLAA-0904
Product options: All
Safety: IEC 61010 -1:2001 (2nd Edition)/ EN 61010 -1:2001
CAN/CSA-C22.2 No. 61010 -1-04 /UL 61010 -1:2004 (2nd Edition)
EMC: EN 61000-6-4:2007 / IEC 61000-6-4:2006
EN 61000-3-2:2006 / IEC 61000-3-2:2005
EN 61000-3-3:1995 + A1:2001 / IEC 61000-3-3:1994 + A1:2001
EN 61000-6-2: 2005/ IEC 61000-6-2:2005
FCC Title 47 CFR, Part 15 Class A
Supplemental Information
To Next Page
Loading...
