5. If your roll has a three-inch cardboard core, ensure that the core adaptors supplied with the printer
have been installed. See below:
6. The roll may be very long; rest the spindle horizontally on a table and load the roll on the table.
Bear in mind that you may need two people to handle it.
7. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle.
NOTE There is also a label on the spindle showing the correct orientation.
Ensure there is no space between the roll and the fixed stop at the right-hand end of the spindle.
8. Put the blue paper stop on to the upper end of the spindle, and push it towards the end of the roll.
ENWW Load a roll onto the spindle [4000] 19
How do I... (paper topics)
To Next Page
Loading...
