10. Wind excess paper back onto the roll. Use the paper stop to turn the roll in the direction shown.
11. The front panel displays a list of paper types.
12. Select the paper type you are using. If it is not clear which you should select, see Using your
printer on CD.
13. The front panel asks you to specify the length of the roll you are loading. After you have done so, it
will start to load the roll.
NOTE Specifying the roll length is not obligatory (you can select Not known) and has
no effect on the printer's behavior. However, if you give the length, subsequently the
printer will keep track of how much paper is used, and will keep you informed of the
remaining length (assuming that the value you originally gave was accurate).
14. If the printer's first attempt to load the roll is unsuccessful, it will automatically wind the paper
backwards and try again without requiring any assistance.
If this second attempt is unsuccessful, it will try a third time, but this time the front panel will request
your assistance.
15. The printer will perform a color calibration, if it has not already calibrated the paper type you are
using, and if color calibration is turned on. See
Perform color calibration.
34 Chapter 3 How do I... (paper topics) ENWW
How do I... (paper topics)
To Next Page
Loading...
