Controlling the cutter
With roll paper loaded, when any print job you have sent to the printer completes, the roll is automatically cut and
the print job falls into the paper bin. There may be a delay before the roll is cut due to the drying time you have
programmed or the printer has automatically selected.
In some situations you may not wish to cut the roll after each print job. Use the following procedure to control the
cutter. The front panel menu selections are:
Select (using the keys)
Then press:
1. Paper menu Enter
2. Cutter Enter
3. ON or OFF Enter
Downloaded from ManualsPrinter.com Manuals
To Next Page
Loading...