Continuable and Non-Continuable Error Codes 101
System Error Codes
SE Code: 32:02 - Take Up Reel disconnected at initialization
Problem Description
This message is shown during initialization of the printer and indicates a warning that the Take Up Reel
has been disconnected while the printer was off. This error is also shown if the user tries to enable the
Take Up Reel but it is not connected to the Printer.
Corrective action:
Connect the Take Up Reel to the Printer and press Ok to continue.
SE Code: 41:03 - Limited electrical voltage at the Media Axis motor
Problem Description:
Electrical current limit in paper motor.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Open the Window and check for any visible obstacles restricting the movement of the Drive Roller. If
there is a wrinkled mass of media inside the paper path, lift the Pinchwheels (using the Media Lever)
and clear the obstruction.
• Replace the Media-Axis Motor ⇒ Page 422.
• If the System Error continues,
replace the PrintMech PCA
⇒
Page 464.
SE Code: 41:10 - Electrical fault at the Media Axis motor
Problem Description:
Electrical fault in Media Axis motor.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Check that the Media-Axis Motor cable is not damaged and is correctly connected to the PrintMech
PCA.
• Replace the Media-Axis Motor ⇒ Page 422.
• If the System Error continues,
replace the PrintMech PCA
⇒
Page 464
SE Code: 42:03 - Problem with the Scan Axis Motor
Problem Description:
Electrical current limit in Scan Axis motor.
Corrective Action:
• Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the
power cord and power On the Printer.
• Open the Window and check for any visible obstacles restricting the movement of the Carriage
Assembly. If there is a wrinkled mass of media blocking the Carriage Assembly, then clear the
obstruction.
To Next Page
Loading...