Continuable and Non-Continuable Error Codes 115
System Error Codes
• Check the cables from the PrintMech to the Air Pump are connected and not damaged.
• Check that the air tubes connected to the air pressure sensor are not pinched and are correctly
connected.
• Check that the air tubes are connected, as this issue could cause this system error to be displayed
• Check the Primer air tubes are connected and not damaged.
• Tap on the relief valve with a screw driver several times to release it from a pressure blockage.
• Remove ALL the Ink Cartridges and reinstall them one by one in to the Printer.
• Replace the APS Assembly ⇒ Page 395.
• Replace the ISS PCA ⇒ Page 391
To Next Page
Loading...