Service Tests 155
Tests, Utilities & Calibrations
19. Reinstall the Printheads into the Carriage.
20. Close the Carriage and close the Front Window.
4.4.3 Recover Broken Bag
Description
This option recovers the printer to a ready status after a broken bag has been detected in one of the Ink
Cartridges.
Procedure
1. Go to Diagnostic test>4. Ink System Menu>4.3 Broken Bag Recovery Menu>4.4.3 Recover Broken
Bag, and press OK.
2. The following message is displayed on the Front Panel, if the Air Tubes are clean of Ink, use the up
and down keys to select “Yes“ and press “Ok“.
3. The following message is displayed on the Front Panel, use the up and down keys to select “Yes“ and
press “Ok“.
NOTE: This option should only be selected if the following has been performed:
• The Ink Cartridge with the broken bag has been replaced with a new Ink
Cartridge
• The Air Tubes have been cleaned of any ink
To Next Page
Loading...