154 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
14 . The following message is displayed on the Front Panel, press any key to continue.
15. The following message is displayed on the Front Panel, press any key to continue.
16. The following message is displayed on the Front Panel, press any key to continue.
17. The following message is displayed on the Front Panel, if more than one bag was detected as
broken or you want to perform the procedure again because the air bubbles have not been
completely cleared, press the “Ok“ key, if you want to finish the procedure and recover the printer
to normal working status, press the “Cancel“ key.
18 . Remove the needle from the FI tower, press any key to continue.
NOTE: If you cannot clear the bubbles from the ink tubes, replace the complete SRK tubes
assembly refer to
⇒
page 380.
To Next Page
Loading...