186 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
5. If the utility exits correctly, OK is displayed on the Front Panel.
1.2.4 Input/Output
Description
The purpose of the IO information service utility is to test the hardware for the installed and active IO
interfaces (Fast Ethernet, Gigabit Ethernet). The IO information service utility checks the hardware involved
in every IO interface and the configuration portion in the firmware.
Procedure
1. Go to Service Test Menu >1.2.4 Input/Output.
2. The front panel displays the following message, press enter to continue.
3. The front panel displays the following message.
4. The front panel displays the following message.
5. The front panel displays the following message.
To Next Page
Loading...