190 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
2. The front panel displays the following message, press the enter key to continue.
3. The front panel displays the results of the test.
4. Press any key to finish.
1. 4 I n k S y s t e m M e n u
1.4.1 Purge Tubes
Description
The purpose of this is to Prime the Tubes when the Ink Tubes are NOT new and they need to be re-primed
or automatic priming was not completed correctly.
Procedure
1. Go to Service Menu >1.4 Ink System Menu>1.4.1 Purge Tubes.
2. If the Ink Cartridges are not suitable for priming, the following message will display on the Front
Panel. Replace the installed Ink Cartridges with Ink Cartridges that are new or contain less than 88%
of ink. Press any key to finish the utility.
3. The front panel displays the following message, press ok to continue purging the tubes.
NOTE: Make sure that NEW Ink Cartridges are installed or that the ink volume remaining in
the Ink cartridges is below 88% before starting to prime the tubes. If you do not comply, you
will get a warning message.
To Next Page
Loading...