Service Menu 191
Tests, Utilities & Calibrations
4. The front panel displays the following message, and then restarts in the purge process.
5. Once the Printer has rebooted, the Front Panel will instruct you to open the Window and remove ALL
the Printheads installed in the Carriage.
6. Once ALL the Printheads have been removed, the Front Panel will instruct you to install the Setup
Printheads into the Carriage
.
7. Once all the Setup Printheads are installed, the following message will display on the front panel.
Close the carriage cover and close the window.
8. The printer will begin to purge the tubes system.
9. Once the tubes system has been purged, the following message will instruct you to open the
Window:
10. Check that the setup printheads have some ink and continue.
To Next Page
Loading...