Service Menu 193
Tests, Utilities & Calibrations
1. 6 C a r r i a g e A s s e m b l y
1. 6 .1. C o l o r S e n s o r ( S p e c t r o p h o t o m e t e r ) C h e c k
Description
The printer uses as a reference an HP Aqueous Media. Use the part number Q1273-60296 if you do not
have any of this type of media available.
Procedure
1. Go to Service Menu >1.6 Carriage Assembly>1.6.1 Color Sensor Check.
2. The printer asks you to use HP Aqueous Media for this test, press any key to continue.
The printer tells you that it will begin to warm up the color sensor, press any key to continue
The printer warms up the Color Sensor for ten minutes, and displays the time remaining.
The printer performs the calibration.
3. The results are displayed on the front panel., press any key to finish the test.
To Next Page
Loading...