HP Designjet L25500 Printer series - Page 202

194 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
1.6.2 Replace Cutter
Description
The purpose of this Service Utility is to move the Carriage to a position where the Cutter can be replaced
easily.
Procedure
1. Go to Service Menu >1.6 Carriage Assembly>1.6.2 Replace Cutter.
2. When the following message displays on the Front Panel, select Ok.
3. The Carriage will move to the Cutter replacement position and the following message will be
displayed on the Front Panel. After a few seconds the Printer will begin to shutdown.
4. Before replacing the Cutter, make sure that you switch the Printer OFF from the rear.
1. 7 S e r v i c e S t a t i o n
1. 7.1. P r i m e Pe n X
Description
The purpose of this is to prime a specific pen.
Procedure
1. Go to Service Menu >1.7 Service Station>1.7.1 Prime Pen X.
2. The following message is displayed on the Front Panel, select OK.