Service Menu 197
Tests, Utilities & Calibrations
Procedure
1. Go to Service Menu >2. Image Quality Plots>Print ALL PLots.
2.2 Printheads Alignment Menu
2.2.1 Test Plot
Description
The Printhead Alignment Test Plot allows you to check the accuracy of the current printhead alignment.
Refer to chapter 5 for more details.
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.2 Printheads Alignment Menu>2.2.1 Test Plot
2.2.2 Advanced Test Plot
Description
The purpose of the Advanced Test Plot is to help you to visually check for any alignment problem in the
printer. Refer to Chapter 5 for detailed information
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.2 Printheads Alignment Menu>2.2.2 Advanced Test
Plot
2.2.3 Automatic Printhead Alignment
Description
This Service Utility triggers an Automatic Printhead Alignment
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.2 Printheads Alignment Menu>2.2.3 Automatic
Printhead Alignment.
2.2.4 Manual Printhead Alignment Menu
2.2.4.1 Print Pattern
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.2 Printheads Alignment Menu>2.2.4 Manual
Printhead Alignment Menu>2.2.4.1 Print Pattern.
2.2.4.2 Manual Alignment Settings
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.2 Printheads Alignment Menu>2.2.4 Manual
Printhead Alignment Menu>2.2.4.2 Manual Alignment Settings.
2.3 Substrate Advance
2.3.1 Substrate Advance Adjustment
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.3 Substrate Advance>2.3.1 Substrate Advance
Adjustment.
2.3.2 Print Adjustment Plot
Description
The purpose of the Print Adjustment Plot is to help you in determining the advance offset in the printer with
the current media loaded. This value has to be introduced to the RIP for adjusting the media advance.
To Next Page
Loading...