196 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
2. To disable the Heating and Curing, select ‘disable’ using the up and down arrows and press the ok
button.
3. If for any reason the printer is unable to disable the Heating and Curing, the following message is
displayed, and the procedure will be cancelled.
4. If the printer is in the correct condition to be disabled, the following message is displayed.
1.11 Show Test Messages
Description
Explains how to enter in to the diagnostics TLC mode
Procedure
1. Go to Service Menu >1.11 Show Test Messages.
2. Image Quality Plots
2.1 Print ALL Plots
Description
The Print ALL Plots allows you to print at once all three diagnostic prints in order to diagnose an image
quality defect. These are the Printhead Alignment, the Printheads Health and Substrate advance. Refer to
chapter 5 for more details.
To Next Page
Loading...