Service Menu 199
Tests, Utilities & Calibrations
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.4 Printheads Health>2.4.5 Clean Y-MK Printheads
2.4.7 Clean LM-M Printheads
Description
Clean LM-M Printheads
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.4 Printheads Health>2.4.5 Clean LM-M Printheads
2.5 Geometry Check
Description
The purpose of this Service plot is to provide a template for checking the printer's length accuracy and
figure distortion. Refer to Chapter 5 for detailed information.
Procedure
1. Go to Service Menu >2. Image Quality Plots>2.5 Geometry Check.
2.6 Geometry Check
Description
The purpose of this Service plot is to help in diagnose any defect in the encoder strip. Refer to Chapter 5
for detailed information.
1. Go to Service Menu >2. Image Quality Plots>2.6 Scan Axis Check.
2.11 Others
Description: Not used
Procedure
3. Inks On Substrate Test
3.1Print Ink Test Plot
Description
The purpose of this Service plot is for determining the level of performance of the Drying and Curing
modules.
Procedure
1. Go to Service Menu >3. Ink On Substrate>3.1 Print Ink Test Plot.
4. Reset Life Counters (NEVER DONE BY CUSTOMER)
4.0 Reset Maintenance Kit Usage
Description
The purpose of this Service Utility is to check the maintenance kit usage and/or reset the life counter of
all the components included in the maintenance kit.
Procedure
1. Go to Service Menu >4. Reset Life Counters>4.0 Reset Maintenance Kit Usage.
2. Select the Service Maintenance Kit for which you want to reset the life counters.
To Next Page
Loading...