206 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
19. The following screen is displayed.
20. The following screen is displayed.
21. The following screen is displayed.
22. The following screen is displayed.
23. Once the calibration is completed successfully, the following message will be displayed on the Front
Panel. Press the OK key to continue.
If the Paper Advance Calibration fails for any reason, a warning message will display on the Front
Panel. In this case, try the following:
• Check that the Calibration Pattern was not incorrectly cut (trimming the actual pattern) during
the media load process. If this is the case, perform the Paper Advance Calibration again from
step 1.
• Perform a Line Sensor Calibration (⇒
page 162) and then re-scan the Calibration pattern.
• Replace the Line Sensor ⇒ page 486.
To Next Page
Loading...