Service Menu 205
Tests, Utilities & Calibrations
14 . The following message is displayed, select OK and follow the on screen instructions to finish the
loading procedure.
15. Load the Calibration Pattern following the instructions on the Front Panel. Once the Calibration
Pattern is loaded correctly, the following message will be displayed on the Front Panel. Press the OK
key to continue.
16. The Printer will scan the Calibration Pattern which could take several minutes.
17. The following screen is displayed.
18 . The following screen is displayed.
NOTE: Only scan the Calibration Pattern in the Printer that was used to actually print it.
Using the Calibration in a different Printer could cause it to experience media advance
problems. After scanning the Calibration Pattern, it should be discarded.
NOTE: When Loading the Calibration Pattern, use the Cutter blade on the Print Platen to
align the edge of the sheet. If you follow this advise, you will prevent the cutter from cutting a
section of the Calibration Pattern, which could cause the Calibration to fail.
To Next Page
Loading...