204 Chapter 4 Service Tests, Utilities & Calibrations
Tests, Utilities & Calibrations
• If necessary, perform a Printhead Recovery through the Front Panel and retry the Calibration.
10. You will need to re-enter the Paper Advance Calibration submenu and scroll to “Scan Calibration
Pattern” and press OK.
11. When the following message displays on the front panel, you must select whether you would like to
continue with the calibration by pressing the OK key. Press Back or Cancel to exit the calibration.
12. A message will display advising you that you will need to load the Calibration Pattern in to the
Printer. Make sure that you rotate the printed pattern 90° clockwise and reload it printed-side down,
so that the black arrows go into the printer first. Press the OK key to continue.
13 . As you are loading a single sheet, the following message will be displayed. Select to skip the check.
NOTE: Remove the pattern from the printer and leave it to dry for a few minutes before
continuing with the Calibration.
NOTE: MAKE SURE NO MEDIA IS LOADED INTO THE PRINTER BEFORE STARTING TO
SCAN THE CALIBRATION PATTERN.
NOTE: Take note that the Calibration Pattern will be loaded as a Roll and NOT as a Sheet.
To Next Page
Loading...