Primer Valves 357
Removal & Installation
Primer Valves
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Right Connector Cover
⇒
See page 341.
3. Disconnect both Primer Valves from the from
Interconnect PCA.
4. Unroute the Primer Valves cables from the from cable
clamp.
5. Completely unroute the Primer Valves cables from the
Service Station.
WARNING!: Switch off the printer and remove the power cable.
NOTE: The upper connection is identified as
number 5 and the lower connection as number
6. These identification numbers correspond to
the actual Primer Valves identification.
To Next Page
Loading...