Rewinder 363
Removal & Installation
9. Remove the Rewinder Assembly making sure that you
do not drop the gears.y.
Installation
1.
Important: Note the position of the gears when
installing the Rewinder Assembly, as they can fall from
the assembly while being installed.
1. When you have installed the new Rewinder Motor,
ensure that the correct cables are connected to the
correct terminals:
• Black cable on the left
• Red cable on the right.
To check the correct electrical installation of the
Rewinder Assembly, perform the diagnostic test “3.6
Rewinder motor polarity”
⇒
See page 143.
2. Perform the following Calibrations:
• “5.3.5 Rewinder C0 voltage calibration”
⇒
See
page 213.
• “4.3.1 Rewinder motor cycles”
⇒
See page 200.
NOTE: The gears of the Rewinder assembly
are loose and could fall as you remove the
assembly.
To Next Page
Loading...