HP Designjet L25500 Printer series - Page 419

Media Jam Sensor, cable & Carriage Reflector Assembly 413
Removal & Installation
Media Jam Sensor, cable & Carriage Reflector
Assembly
Removal
1. Remove the Left Cover ⇒ page 325.
2. Remove the Rear Cover ⇒
3. Remove the Left Connector Cover:
• For the 42-inch model ⇒ See page 343.
• For the 60-inch model ⇒ See page 344.
4. Remove two T-15 screws from the Media Jam Sensor.
5. Remove the Media Jam Sensor Plate.
6. Remove the Media Jam Sensor from the clip on the Left
Scan-Axis Bracket.
WARNING!: Switch off the printer and remove the power cable.