HP Designjet L25500 Printer series - Page 428

422 Chapter 8 Removal & Installation
Removal & Installation
Media-Axis Motor
Removal
1. Remove the Left Cover ⇒ See page 325 .
2. Remove the Rear Cover ⇒ See page 332 .
3. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 343.
• For the 60-inch model, the Electronics Module
Extension⇒ See page 344.
4. Disconnect the Media-Axis Motor cable from the
PrintMech PCA.
5. Detach the clamp of the ferrite core of the Media-Axis
Motor cable from the printer chassis.
6. Remove the T-15 screws (Type R) identified (A) and
loosen the T-15 screws (Type R) identified (B) that
secure the Media-Axis Motor.
WARNING!: Switch off the printer and remove the power cable.
B
A