Media-Axis Motor 423
Removal & Installation
7. Remove the Media-Axis Motor Bracket.
8. Remove two T-20 screws (Type B) that secure the
Media-Axis Motor Bracket.
9. Remove the Media-Axis Motor from the Printer.
NOTE: When reinstalling the parts, make sure
you apply the grease (included with the support
part) to the gears.
NOTE: After installing the NEW Media-Axis
Motor, make sure you perform the following
Service Calibration:
• “5.3.1 Paper Advance Calibration”
⇒
See
page 201.
• “4.3.2 Drive Roller Motor”
⇒
See
page 200.
To Next Page
Loading...