424 Chapter 8 Removal & Installation
Removal & Installation
Optical Media Advance Sensor (OMAS)
Removal
1. Remove the Left Cover
⇒
See page 325
.
2. Remove the Right Cover
⇒
See page 319
.
3. Remove the Rear Cover
⇒
See page 332
.
4. Remove media if installed.
5. Remove one T-10 screw from the Media sensor
holding bracket.
6. Remove the holder of the Media Sensor.
7. Unclip the Media sensor from the platen underside.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...