430 Chapter 8 Removal & Installation
Removal & Installation
10. Clip the Media Sensor to the Center Guide.
11. Install the holder of the Media Sensor.
12. Install one T-10 screw into the Media sensor holding
bracket.
13 . Clip the OMAS access cover back into place by
sliding one edge of the cover into the slot and then
applying enough pressure to it so you can clip it into
the other slot.
NOTE: After installing the NEW OMAS,
perform the following Service Calibration:
• “5.3.2 Calibrate the OMAS”
⇒
See
page 207.
• “5.3.3 OMAS Temp”
⇒
See page 211.
• Reset the life counter “4.3.3.Reset OMAS
Sensor cycle”
⇒
See page 200.
To Next Page
Loading...