TOMAS: Temperature Optical Media Advance Sensor 431
Removal & Installation
TOMAS: Temperature Optical Media Advance Sensor
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Rear Cover
⇒
See page 332
.
3. Remove media if installed.
4. Remove OMAS
⇒
See page 424
.
5. Remove one T10 screw that secures the TOMAS to the
under side of the platen.
6. Release TOMAS from the holder in the plate.
WARNING!: Switch off the printer and remove the power cable.
NOTE: To simplify the installation of the TOMAS an Attachment Screw Retainer has been added to hold
the two T-20 attachment screws. This part is delivered attached to the replacement TOMAS unit with the
two attachment screws. It is also delivered as a separate part with the Center Platen in case the TOMAS
is completely removed during its replacement.
To Next Page
Loading...