432 Chapter 8 Removal & Installation
Removal & Installation
7. Pull out the TOMAS and cable from the underside of
the platen, and disconnect the cable.
8. For installing the new TOMAS a screw is held in the
bracket for easier installation.
9. Insert the new TOMAS into the hole underneath the
platen.
10. Tighten the screw held by the bracket into the platen.
11. There are some important notes on installing the
OMAS if it has been removed while removing the
TOMAS
⇒
See page 427
.
12. Install the screw holder onto the OMAS and reinstall it.
To Next Page
Loading...