OMAS Cable 439
Removal & Installation
OMAS Cable
Removal
1. Remove the Right Cover
⇒
See page 319
.
2. Remove the Right Connector Cover
⇒
See page 341
.
3. Remove the Service Station
⇒
See page 364
.
4. Remove the OMAS
⇒
See page 424
.
5. Remove one T-15 screw that secures the OMAS Cable
clamp from the printer.
6. Remove the OMAS Cable clamp from the printer.
7. Carefully Pull the OMAS Cable out of the Vacuum
Beam.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...