HP Designjet L25500 Printer series - Page 488

482 Chapter 8 Removal & Installation
Removal & Installation
PrintMech PCA
Removal
1. Remove:
• For the 42-inch model, the Left Connector Cover
⇒ See page 343.
• For the 60-inch model, the Electronics Module
Extension ⇒ See page 344.
2. Remove the Heaters Control Assembly ⇒ See
page 465.
3. Disconnect ALL cables from the PrintMech PCA.
4. Remove eight T-10 screws (Type I) that secure the
PrintMech PCA.
5. Remove the PrintMech PCA from the Printer.
WARNING!: Switch off the printer and remove the power cable.