Electronics Module 483
Removal & Installation
Electronics Module
Removal
1. Remove the Right Connector Cover
⇒
See page 341.
2. Remove the Left Connector Cover:
• For the 42-inch model ⇒ See page 343.
• For the 60-inch model ⇒ See page 344.
3. Disconnect ALL the cables connected to the right
Interconnect PCA and the Sausalito PCI PCA.
4. Unroute all the disconnected cables so they are clear
of the Electronics Module.
x
5. Remove two T-20 screws (Type B) that secure the right
side Electronics Module.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...