496 Chapter 8 Removal & Installation
Removal & Installation
Dryer (IR) Temperature Sensor
Removal
1. Twist the Window Locks and open the Dryer Window.
2. Remove the Left Cover
⇒
See page 325
.
3. Disconnect the Dryer Temperature Sensor cable from
the left side of the printer.
4. Remove one T20 screws from the cable clamp.
5. Remove all the T20 screws from cable clamps that
secure the Temperature Sensor Cable to the inside of
the Dryer Window Assembly.
WARNING!: Switch off the printer and remove the power cable.
To Next Page
Loading...