HP Designjet L25500 Printer series - Page 503

Dryer (IR) Temperature Sensor 497
Removal & Installation
6. Remove two thin nuts from the Dryer Temperature
Sensor.
7. Remove the Dryer Temperature Sensor from the holder.
8. Remove the Dryer Temperature Sensor Cable from the
cable clamps.
9. Remove the Dryer Temperature Sensor and cable from
the printer.
NOTE: After installing the NEW Dryer IR
temp sensor, perform the following Service
Calibrations:
• Reset the life counter “4.8.4 Reset Heating
Sensor”
⇒ page 201.