498 Chapter 8 Removal & Installation
Removal & Installation
Dryer Heater
Removal
1. Remove the Left Cover
⇒
See page 325
.
2. Remove the Dryer Grills
⇒
See page 494
.
3. Remove one T-10 screw from a clamp that secures the
cable of the Dryer Heater.
4. Loosen two screws on the connector of the Dryer IR
Temperature Sensor cable, by hand or with a flat
screwdriver, and disconnect.
5. Remove one T25 screw, one lock washer, one normal
washer that secures the grounding cable.
WARNING!: Switch off the printer and remove the power cable.
WARNING!: To ensure the electrical safety of
the Printer, it is very important that this ground-
ing cable is reinstalled after the new part has
been installed.
To Next Page
Loading...