502 Chapter 8 Removal & Installation
Removal & Installation
17. Remove all the T-20 screws that secure the Dryer
Assembly to the inside of the window. The number of
screws will depend on the Printer size.
18 . When all of the T-20 screws have been removed, you
can remove the Dry Assembly from inside the Window.
CAUTION: We recommend that the last
screw to be removed is one of the central
screws. Take care when removing the last
holding screw, that holds the Dryer Assembly
as it could fall.
NOTE: After installing the NEW Dryer Heater
perform the following:
• “8.6 Heating Resistance resist”
⇒
page 171.
• Reset the life counter “4.8.3Heating Lamps”
⇒
page 201.
To Next Page
Loading...